Carbon Monoxide and Your Furnace: the California Law, and Why a Compliant Alarm Isn’t a Safe Furnace

California has required carbon monoxide alarms in most homes since 2011, and the rules about where they go are more specific than most people realise. But a house can satisfy every one of them and still contain a furnace nobody has looked inside. Here is the law in plain terms, and then the part the legal pages leave out: what actually produces carbon monoxide in a gas furnace.

If an alarm is sounding right now

Everyone out of the house first. Then call 911 from outside. Don’t look for the source, don’t start opening windows, and don’t spend time deciding whether it might be a false alarm. Carbon monoxide has no smell and no colour, so there is nothing for you to check with your own senses, and that is exactly why the alarm exists. Once the house has been made safe, the furnace needs looking at by somebody licensed before it runs again.

What the law actually requires

The California Carbon Monoxide Poisoning Prevention Act is the statute behind it. The short version is that if your home burns any fossil fuel, or has a garage attached to it, you need an approved carbon monoxide alarm. Gas furnace, gas water heater, gas range, fireplace, attached garage: any one of those puts you inside the requirement.

What the law covers In plain terms Where it comes from
Which homes Any dwelling with a fossil-fuel appliance or an attached garage. A genuinely all-electric home with neither is generally exempt. Carbon Monoxide Poisoning Prevention Act
Single-family deadline 1 July 2011. If your house predates that and nobody has fitted alarms since, it is not compliant now. Statutory date
Multifamily deadline 1 January 2013, covering apartments, duplexes and similar dwellings. Statutory date
Placement Outside each separate sleeping area, on every occupiable level, and inside any bedroom containing a fuel-burning appliance. City of San Diego Fire
The device Must be approved and listed by the State Fire Marshal. Check the unit or its packaging rather than assuming. State Fire Marshal listing

This is a plain-terms summary of published requirements so you can check your own home, not legal advice. If you’re a landlord weighing obligations, read the statute and the fire authority guidance directly rather than relying on a contractor’s summary.

Two details in that table catch people out. The first is placement, because a single alarm in a hallway is the common arrangement and frequently isn’t sufficient on its own. The requirement is per sleeping area and per occupiable level, which in a two-storey house with bedrooms at both ends means more than one device. The second is the State Fire Marshal listing, which is a genuine filter rather than paperwork. A working alarm that isn’t listed doesn’t meet the requirement.

Worth saying plainly: an all-electric house with no fuel-burning appliance and no attached garage is generally outside all of this. It’s one of the few real advantages of going all-electric that nobody mentions in the efficiency and energy-cost conversation.

Why a compliant house can still have an unsafe furnace

Here is the gap that almost nothing written about this subject closes. The legal pages tell you which alarms to buy and where to put them, and then they stop. The alarm is a detector. It tells you that carbon monoxide has already reached the room you mounted it in. It tells you nothing whatsoever about the condition of the appliance that produced it.

What an alarm does

Warns you once CO is already in the air where you’re standing. Genuinely saves lives and is legally required. It is the last line of defence.

What an alarm doesn’t do

Say anything about the state of the heat exchanger, the burners or the flue. A furnace can be producing CO into the exhaust for a long time before an alarm has anything to react to.

The distinction matters because the two things get used interchangeably. Fitting alarms is compliance. Having the appliance checked is safety. You want both, and one is not a substitute for the other.

Heating system never actually been looked at? Call (951) 513-8476 We’re C-20 licensed, CA Lic. #1070401, and the estimate is free and written before anything starts.

What produces carbon monoxide inside a gas furnace

A gas furnace burns fuel deliberately and is built so the products of that combustion go up the flue and out, while the air blown around your house stays on the other side of a metal wall. Carbon monoxide becomes a problem when one of three things goes wrong with that arrangement.

A cracked heat exchanger

The heat exchanger is the metal wall between the flames and the air that goes into your rooms. It expands and contracts every time the furnace fires, thousands of times over its life, and eventually it can crack. When that happens, combustion gases get into the air being blown through the house. This is the serious one, and it’s also the one that cannot be seen from outside the cabinet or diagnosed by smell.

Incomplete combustion

Burning gas cleanly needs the right amount of air. Starve the burners of it, with a badly blocked filter, a restricted return or a dirty burner assembly, and the fuel burns incompletely, producing carbon monoxide instead of the harmless products of a clean burn. This is why airflow problems are a safety subject and not only an efficiency one.

A blocked or disconnected flue

The flue is what takes the exhaust out of the building. It can corrode, it can get blocked by a bird’s nest or debris, and in an attic or a crawl space a section can quite simply come apart. When that happens the furnace burns perfectly well and vents into the house instead of outside.

All three are inside or behind the furnace cabinet. None of them is on a homeowner’s list, and in California this is work that needs a C-20 licence. Ours is CA Lic. #1070401, and you should ask for the number from anyone you let near a gas appliance.

What a proper check involves

Established practice in the trade is that combustion gets measured rather than eyeballed. A combustion analyser samples the flue gas and reads what is actually coming out of the appliance, which is a different kind of evidence from looking at the colour of a flame and forming an impression. A heat exchanger is inspected visually, usually with a camera, because the surfaces that matter aren’t reachable by eye.

The reason to know what that looks like is so you can ask for it specifically. A heating service that never measures anything and never looks inside the cabinet has not assessed the safety of the appliance, whatever the invoice says. Ask what will be measured and what will be inspected, and ask for the readings. Any competent contractor will be happy to be asked.

It’s also worth being honest about the limit of this. No inspection makes an appliance permanently safe, because a heat exchanger can crack the week after somebody looked at it. What an inspection does is find the faults that are already there, which is a great deal better than finding out from an alarm.

Cost, and the point where it becomes a replacement

Most furnace repairs land between $150 and $900, with the average near $350 to $400 according to published 2026 national figures (HomeGuide, 2026), and labour runs $75 to $150 an hour on top. Combustion faults spread across that range. A blocked flue or a dirty burner assembly is usually at the cheap end. A blower or control problem behind an airflow fault can reach $400 to $900.

A cracked heat exchanger is a different conversation, because on most systems it is not a repair. The exchanger is the core of the furnace, and on anything other than a nearly-new unit the sensible answer is replacement rather than a part. The rough test still applies: multiply the furnace’s age in years by the quote, and if the answer clears about $5,000, replacing is normally the better buy. On a cracked exchanger in an older system that arithmetic is rarely close.

There is one consolation. A furnace old enough to have a failed heat exchanger is also old enough to be burning noticeably more gas than a current one for the same warmth, so the replacement usually improves the utility bill as well as the safety position. It’s worth asking what rebate money is available before deciding, because that can move the numbers further than people expect.

The short version

Fit alarms to the placement rules rather than the habit, check that they carry the State Fire Marshal listing, and test them. Then get the appliance itself looked at before the heating season rather than after something goes wrong, and ask what was measured. Our winter maintenance checklist covers the seasonal sequence, and our heating services covers the wider picture.

Two related pages worth a look if you got here from a symptom rather than from the law. A burning smell on the first use of the season explains which smells are harmless dust and which ones mean shut it down, and note that carbon monoxide is not among them because it has no smell. A furnace that won’t turn on walks the five checks that are genuinely yours to make. Or just get in touch and describe what’s happening.

Not sure when your furnace was last opened up? Call (951) 513-8476 Free estimate, flat price in writing before anything starts, and we’ll say straight out if it needs more than a service.

Carbon monoxide and gas heating: common questions

Are carbon monoxide alarms required by law in California?

Yes, for most homes. The California Carbon Monoxide Poisoning Prevention Act requires an approved alarm in any dwelling that has a fossil-fuel appliance or an attached garage. The deadline for single-family homes was 1 July 2011, and for multifamily dwellings it was 1 January 2013. A home that is genuinely all-electric, with no fuel-burning appliance and no attached garage, is generally outside the requirement.

Where do carbon monoxide alarms have to be installed?

Outside each separate sleeping area, on every occupiable level of the home, and inside any bedroom that itself contains a fuel-burning appliance. That’s the placement the City of San Diego Fire Department sets out, and it’s the pattern to follow. One alarm in a hallway is a common arrangement and it is often not enough on its own.

Does any carbon monoxide alarm count?

No. The device has to be approved and listed by the State Fire Marshal. That’s a real filter rather than a formality, and it’s worth checking the packaging or the back of the unit for the listing rather than assuming. An alarm that isn’t listed doesn’t satisfy the requirement even if it works.

If my alarm is compliant, is my furnace safe?

Not necessarily, and this is the part most pages skip. The alarm tells you carbon monoxide has already reached the room you put it in. It says nothing about the condition of the appliance producing it. A house can be fully compliant with the law and still contain a furnace with a cracked heat exchanger or a flue that came apart in the attic. The alarm is the last line of defence, not the first.

What actually produces carbon monoxide in a gas furnace?

Three things, broadly. A cracked heat exchanger, which lets combustion gases into the air being blown through the house. Incomplete combustion, where the burners aren’t getting the air they need and produce CO instead of burning cleanly. And a blocked, corroded or disconnected flue, which means the exhaust never leaves the building. All three are inside or behind the cabinet, which is why none of them is a homeowner check.

My carbon monoxide alarm is sounding. What do I do?

Get everyone out of the house first, then call 911 from outside. Don’t spend time looking for the source, opening windows or working out whether it might be a false alarm. Once the house is safe, the furnace needs looking at by somebody licensed before it runs again. Carbon monoxide has no smell at all, so you cannot use your nose to second-guess an alarm.

About the author

Written by the team at SoCal AC Guy, a C-20 licensed heating and air conditioning contractor covering Temecula, Murrieta, Menifee, Lake Elsinore and the surrounding Inland Empire. The business is owned and run by Jorge, CA Lic. #1070401. The legal summary on this page follows the California Carbon Monoxide Poisoning Prevention Act together with published placement guidance from the City of San Diego Fire Department, and the prices come from published 2026 national cost data. It is a plain-terms summary for homeowners, not legal advice. More about us.